XRAY Legacy Parts

Low-friction 3.5mm drive pin clips for protecting and cushioning drive shaft pin in diff outdrives. Made from all-new, extra-strong composite mixt...

Molded composite 4.9mm ball joints, open on both sides, for connection to 4.9mm ball. Set of eight. Fits XRAY T2, T3, T4, RX8, XB8, NT1, X1 and GTX8

This is a pack of four replacement XRAY Differential Gaskets, and is intended for use with the XRAY T3 family of 1/10 touring cars equipped with th...

Molded composite C-hub for right steering block of T2, T3. Caster pre-set at 4°. Medium rigidity for rubber-tire racing. Use with matching left-si...

Molded-composite rear upright features built-in 0° of outboard toe to improve traction and prevent suspension geometry changes in serious crashes....

Molded composite C-hub for right steering block of T2, T3. Caster pre-set at 4°. Medium rigidity for rubber-tire racing. Use with matching left-si...

Complete gear differential set for XRAY T3 includes composite differential case and cover with pulley. Differential gears are made from tough compo...

Precision-molded 20T layshaft pulleys for XRAY T2’008, T2'009 and T3 includes composite shims. Standard pulleys for XRAY T2’008, T2'009, T3 US Foa...

Precision-molded 20T layshaft pulley made of specially-formulated graphite composite material that is a perfect balance of reliability and perform...

Threaded 4.9mm ball end with 5mm thread length for connection to molded ball joints. Set of 2.

Rubber O-ring fits over 5mm shaft. 1mm thick. Set of 10 pieces.

Threaded 4.9mm ball end with 10mm thread length for connection to molded ball joints. Set of 2.

Molded-composite rear upright features built-in 0° of outboard toe to improve traction and prevent suspension geometry changes in serious crash...

Specially-modified high-performance 513mm-long and 3mm-wide front drive belt comes standard in XRAY T2’009 Rubber-Spec Conversion Set - 38T Pulley....

Specially-modified high-performance 189mm-long and 3mm-wide rear drive belt comes standard in XRAY T2’009 Rubber-Spec Conversion Set – 38T Pulley.T...

Polished chrome pin for ECS drive shaft, 2.0 x 9.0mm. Specially hand-ground for maximum precision. To help prevent of loosening of the setscrew fr...

XRAY precision molded offset spur gear 81 tooth, 48 pitch. This spur gear has been strategically lightened to reduce rotating mass.

Molded composite 4.9mm ball joints, special construction. For connection to 4.9mm ball. Set of four. Fits XRAY T2, T3.

Alu shims 3x6mm size, 4mm thick, set of 10. Available in Black & Silver

Set of two adjustable steering rod turnbuckles, manufactured from world-renowned top-secret "Hudy Spring Steel". Product released: 4th July 2002

Alu shims 3x6mm size, 2mm thick, set of 10. Available in Black, Orange and Silver

High-speed ball-bearings manufactured specially for XRAY. ID x OD x thickness (mm) = 10x15x4. Top-quality professional ball-bearings for a super-fr...

5mm dia. E-clip. Set of 10 pieces.

Carbide balls 2.4mm for ball differential. Improved, smoother diff operation over standard steel diff balls. These carbide balls are much harder th...